Raspberry PI 433MHz Remote Controlled Power Plugs
First you’ll need to buy a set of remote controlled power plugs. I got mine from pollin.de for around 10 €.
Connect your 5V VCC from the GPIO pins of your Raspberry PI to the positiv terminal of your remote control. Connect the GCN GPIO pin to the negativ terminal of your remote control. Connect the PIN 17 GPIO pin to a 8k Ohm resistor and the resistor to pin P1 of the remote control. I drilled a hole trough the existing via and scrapped away the soldermask to expose the copper for soldering a connection in place.
Execute test command
// Send off command to plug 4 with system id 11111 ./send 11111 4 0 // Send on command to plug 4 with system id 11111 ./send 11111 4 1